Download Troubleshooting Cisco Data Center Infrastructure (DCIT).300-615.Pass4Sure.2020-03-27.36q.vcex

Vendor: Cisco
Exam Code: 300-615
Exam Name: Troubleshooting Cisco Data Center Infrastructure (DCIT)
Date: Mar 27, 2020
File Size: 3 MB
Download Exam

How to open VCEX files?

Files with VCEX extension can be opened by ProfExam Simulator.

Download
ProfExam Simulator

Purchase
Coupon: EXAM_HUB

Discount: 20%

ProfExam Simulator ProfExam Simulator ProfExam Simulator ProfExam Simulator ProfExam Simulator

Demo Questions

Question 1
A vPC Type-1 inconsistency between two vPC peers in a VXLAN EVPN setup is discovered. Which two actions need to be attempted to resolve the issue? (Choose two.)
  1. Configure the NVE interfaces to be Up on both switches.
  2. Set a different distributed gateway virtual MAC address.
  3. Set a different secondary IP addresses on NVE source-interface.
  4. Configure the same VNI to multicast group maping.
  5. Set a different primary IP addresses on NVE source-interface.
Correct answer: AD
Question 2
  
Refer to the exhibit. An OSPF adjacency between Router-A and Router-B cannot reach the FULL state. Which action resolves the issue?
  1. Adjust the MTU on Router-A to 1600.
  2. Disable the check of the MTU value.
  3. Set the OSPF media type to point-to-point.
  4. Adjust the MTU on Router-B to 1604.
Correct answer: B
Question 3
The Cisco Nexus switch is connected to a peer switch that is not running Cisco NX-OS. The switches are connected using port channel and are experiencing packet loss. Which action should be performed on the Cisco Nexus switch ports to resolve this issue?
  1. Turn on lacp suspend-individual.
  2. Turn on lacp graceful-convergence.
  3. Turn off lacp graceful-convergence.
  4. Turn off lacp suspend-individual.
Correct answer: C
Question 4
  
Refer to the exhibit. The HSRP instance on both switches is showing as active. Which action resolves the issue?
  1. Configure the HSRP timers to be the same.
  2. Allow VLAN 100 between the switches.
  3. Configure the IP address of N9K-B on the same subnet as N9K-A.
  4. Configure preempt on only one of the switches.
Correct answer: B
Question 5
An engineer is troubleshooting a fabric discovery failure. Which two requirements must an engineer verify about switch connectivity to solve the problem? (Choose two.)
  1. A Cisco APIC must be attached to a spine node only.
  2. A Cisco APIC must be attached to leaf nodes.
  3. Spine nodes must connect to other spine nodes.
  4. A Cisco APIC must be dual-attached to two separate spine nodes.
  5. Leaf nodes must connect to spine nodes only.
Correct answer: BE
Question 6
  
Refer to the exhibit. A network engineer has connected the Nexus switch management port to the Internet using DHCP to allow the Guest shell running on the switch to download Python packages. The engineer can ping google.com successfully from the Nexus switch, but the Guest shell failed to download any Python packages. Which action resolves the problem?
  1. Update the Python packages on the Cisco Nexus switch directly.
  2. Manually configure DNS in the Guest shell, even if it is claimed on the Cisco Nexus switch through DHCP.
  3. Manually configure NTP in the Guest shell.
  4. Connect Guest shell to data plane interfaces to be able to connect to the networks outside the Cisco Nexus switch.
Correct answer: B
Question 7
  
Refer to the exhibit. vPC between switch1 and switch2 is not working. Which two actions are needed to fix the problem? (Choose two.)
  1. Match vPC domain ID between the two devices.
  2. Configure IP address on the interface.
  3. Activate VLANs on the vPC.
  4. Configure vPC peer link and vPC peer keepalive correctly.
  5. Configure one of the switches as primary for the vPC.
Correct answer: AC
Question 8
  
Refer to the exhibit. Sw1 and Sw2 are two Cisco Nexus 9000 Series Switches that run Cisco NX-OS. They are VTEPs in the same vPC domain. Which statement describes what happens in this scenario?
  1. Sw1 drops all traffic because there is no (S, G) OIF list to encapsulate VXLAN multicast packets and send them out to the underlay network through the uplink interfaces.
  2. Sw1 performs the VxLAN multicast encapsulation and decapsulation for all traffic associated with the VxLAN VNIs.
  3. Sw1 and switch 2 perform the VxLAN multicast encapsulation and decapsulation for all traffic associated with the VxLAN VNIs, depending on the hashing.
  4. Sw2 did not send an IP PIM register to the rendezvous point for the multicast group of the VXLAN VNI.
Correct answer: B
Question 9
A customer configures HSRP between two data centers that are interconnected with OTV. The configuration succeeds, but traffic between two ESXi virtual hosts on the same site is routed suboptimally through the OTV overlay. Which two actions optimize the traffic? (Choose two.)
  1. Disable first-hop redundancy.
  2. Filter HSRP traffic by using a Layer 3 VACL on the OTV edge devices.
  3. Filter HSRP by using a Layer 2 MAC-list on the ESXi vSwitch.
  4. Filter HSRP traffic by using a Layer 3 VACL on the ESXi vSwitch.
  5. Filter HSRP by using a Layer 2 MAC-list on the OTV edge devices.
Correct answer: AB
Question 10
An engineer removes a VMM domain from an endpoint group called EPG-1, but the distributed port group fails to be deleted. Which action must be taken to resolve the issue?
  1. Remove the port group manually.
  2. Migrate all virtual machines in the EPG-1 to different hypervisors.
  3. Remove the remaining EPGs from the VMM domain.
  4. Migrate all virtual machines in the EPG-1 to different port groups.
Correct answer: C
CONNECT US
HOW TO OPEN VCE FILES

Use VCE Exam Simulator to open VCE files
Avanaset

HOW TO OPEN VCEX AND EXAM FILES

Use ProfExam Simulator to open VCEX and EXAM files
ProfExam Screen

ProfExam
ProfExam at a 20% markdown

You have the opportunity to purchase ProfExam at a 20% reduced price

Get Now!